Difference between revisions of "Cromemco 8K Bytesaver"

From TheRetroWagon
Jump to: navigation, search
(changed category from s-100 to s-100 Boards)
(Resources: add category ME2700)
 
(4 intermediate revisions by the same user not shown)
Line 8: Line 8:
  
 
Here is the .PRN file from a simple program I loaded into a 2708 to test my ability to program an EPROM with Martin Eberhard’s post era ME2700 Orphan EPROM Programmer. On my Imsai front panel I examined the address C000 then pressed run. Yup the programmed output LEDs change state based on the programmed input paddle switches.  
 
Here is the .PRN file from a simple program I loaded into a 2708 to test my ability to program an EPROM with Martin Eberhard’s post era ME2700 Orphan EPROM Programmer. On my Imsai front panel I examined the address C000 then pressed run. Yup the programmed output LEDs change state based on the programmed input paddle switches.  
 
Now it's off to find a simple monitor program to load in EPROM(s) and decide which I/O card to use for serial communications.
 
  
 
<source lang="text">
 
<source lang="text">
Line 25: Line 23:
 
</source>
 
</source>
  
 +
==Resources==
 +
* ME2700 EPROM programmer firmware and documentation located [https://drive.google.com/folderview?id=0B-XdfCubTNJJRnB2cXpQM1RBMWs&usp=drive_web here.]
 +
* Martin Eberhard [https://drive.google.com/drive/folders/0B-XdfCubTNJJNW54UWJJVnpKMlE MEMON80] Rev. 1.1
 +
 +
Now it's off to find a simple monitor program to load in EPROM(s) and decide which I/O card to use for serial communications.
  
  
Line 30: Line 33:
 
[[Category:S-100 Boards]]
 
[[Category:S-100 Boards]]
 
[[Category:Operational]]
 
[[Category:Operational]]
 +
[[Category:Martin Eberhard]]
 +
[[Category:ME2700]]

Latest revision as of 16:04, 10 August 2018

8K Bytesaver.jpg


Cromemco 8K Bytesaver EPROM board. Working. My dad and I each built one of these. I think this one was mine.

Here is the .PRN file from a simple program I loaded into a 2708 to test my ability to program an EPROM with Martin Eberhard’s post era ME2700 Orphan EPROM Programmer. On my Imsai front panel I examined the address C000 then pressed run. Yup the programmed output LEDs change state based on the programmed input paddle switches.

                ; jha 2/10/2016 !Light data LED for corresponding switch
                ; ImsaiTp1.asm Imsai Test Program 1 from pp. 35. of Imsai documentation.
                
                START:
 C000           		org		0c000h
                		
                LOOP:
 C000 DBFF      		in		0FFh
 C002 D3FF      		out		0FFh
 C004 C300C0    		jmp		LOOP
 C007                   end

Resources

  • ME2700 EPROM programmer firmware and documentation located here.
  • Martin Eberhard MEMON80 Rev. 1.1

Now it's off to find a simple monitor program to load in EPROM(s) and decide which I/O card to use for serial communications.