Difference between revisions of "Ithaca Intersystems DPS-1"
(Added detailed images of tear down.) |
(Add manuals) |
||
| Line 18: | Line 18: | ||
The chassis has threaded attached standoffs. Quite a lot easier to reassemble this FP than the Imsai FPs. Rock solid power supply voltage tested with my EEVBlog meter. | The chassis has threaded attached standoffs. Quite a lot easier to reassemble this FP than the Imsai FPs. Rock solid power supply voltage tested with my EEVBlog meter. | ||
| − | [[File:Ithaca Front panel PCB.jpg|400px]] | + | [[:File:Ithaca Front panel PCB.jpg|400px]] |
Lot's of options on this FP | Lot's of options on this FP | ||
==Resources== | ==Resources== | ||
| − | + | ===Manuals=== | |
| + | I found these manuals [https://amaus.net/static/S100/intersystems/cards/ here] at https://amaus.net/static/S100/intersystems/ | ||
| + | * [[:File:Ithaca Intersystems Z80 CPU Manual 1977.pdf|Ithaca Intersystems Z80 CPU Manual 1977]] | ||
| + | * [[:File:Ithaca Intersystems Hard Disk Adaptor.pdf|Ithaca Intersystems Hard Disk Adaptor]] | ||
| + | * [[:File:Ithaca Intersystems Front Panel.pdf|Ithaca Intersystems Front Panel]] | ||
| + | * [[:File:Ithaca Intersystems FDC-2 Disk Controller Manual.pdf|Ithaca Intersystems FDC-2 Disk Controller Manual]] | ||
| + | * [[:File:Ithaca Intersystems FDC-2 Bootstrap.pdf|Ithaca Intersystems FDC-2 Bootstrap]] | ||
| + | * [[:File:Ithaca Intersystems 64K DRAM Rev 0 Manual 1980.pdf|Ithaca Intersystems 64K DRAM Rev 0 Manual 1980]] | ||
| + | * [[:File:Ithaca Intersystems Series II MPU-80.pdf|Ithaca Intersystems Series II MPU-80]] | ||
Revision as of 17:56, 20 April 2017
Functional front panel and z80 board. Pictured running the port FF test program testing input and output to port 0xFF. Note the corresponding programmed output LEDs to the Address-Programmed Input
See the clear vinyl bubbled up? I'm not sure if that was part of the shipping that you peel off, or a protective layer meant to be a permanent part of the system. Needs attention RSN.
I have a Intersystems Model 950 set of disk drives working too. I've got a bit of RTFM to do first before trying to boot any media I may have.
I removed all the boards and the front panel (FP) board before testing the power supply. It was rock solid.
Detail of key lock (in case I rekey)
The chassis has threaded attached standoffs. Quite a lot easier to reassemble this FP than the Imsai FPs. Rock solid power supply voltage tested with my EEVBlog meter.
Lot's of options on this FP
Resources
Manuals
I found these manuals here at https://amaus.net/static/S100/intersystems/
