Difference between revisions of "Cromemco 8K Bytesaver"
(Added resources heading and MEMON80 and Martin Eberhard category) |
(→Resources: add rev 1.1) |
||
| Line 25: | Line 25: | ||
==Resources== | ==Resources== | ||
* ME2700 EPROM programmer firmware and documentation located [https://drive.google.com/folderview?id=0B-XdfCubTNJJRnB2cXpQM1RBMWs&usp=drive_web here.] | * ME2700 EPROM programmer firmware and documentation located [https://drive.google.com/folderview?id=0B-XdfCubTNJJRnB2cXpQM1RBMWs&usp=drive_web here.] | ||
| − | * Martin Eberhard [https://drive.google.com/drive/folders/0B-XdfCubTNJJNW54UWJJVnpKMlE MEMON80] | + | * Martin Eberhard [https://drive.google.com/drive/folders/0B-XdfCubTNJJNW54UWJJVnpKMlE MEMON80] Rev. 1.1 |
Now it's off to find a simple monitor program to load in EPROM(s) and decide which I/O card to use for serial communications. | Now it's off to find a simple monitor program to load in EPROM(s) and decide which I/O card to use for serial communications. | ||
Revision as of 14:56, 1 December 2016
Cromemco 8K Bytesaver EPROM board. Working. My dad and I each built one of these. I think this one was mine.
Here is the .PRN file from a simple program I loaded into a 2708 to test my ability to program an EPROM with Martin Eberhard’s post era ME2700 Orphan EPROM Programmer. On my Imsai front panel I examined the address C000 then pressed run. Yup the programmed output LEDs change state based on the programmed input paddle switches.
; jha 2/10/2016 !Light data LED for corresponding switch
; ImsaiTp1.asm Imsai Test Program 1 from pp. 35. of Imsai documentation.
START:
C000 org 0c000h
LOOP:
C000 DBFF in 0FFh
C002 D3FF out 0FFh
C004 C300C0 jmp LOOP
C007 end
Resources
Now it's off to find a simple monitor program to load in EPROM(s) and decide which I/O card to use for serial communications.
