Difference between revisions of "CompuPro Interfacer 3"
(Initial creation) |
(Revert capital P in Compu P ro) |
||
| (2 intermediate revisions by the same user not shown) | |||
| Line 11: | Line 11: | ||
set baud 9600 | set baud 9600 | ||
set port 7 | set port 7 | ||
| + | ; be sure the correct stop bits etc. are set corectly | ||
| + | ; In TeraTerm I found it helpful to set the 1k block checkbox. | ||
| + | ; to receive using xmodem, M for modem 7; 'mr filename' | ||
</syntaxhighlight> | </syntaxhighlight> | ||
==Documentation== | ==Documentation== | ||
| Line 25: | Line 28: | ||
[[Category:Operational]] | [[Category:Operational]] | ||
| − | [[Category: | + | [[Category:Compupro]] |
| + | [[Category:Mex]] | ||
Latest revision as of 16:07, 19 December 2020
Interfacer 3 page mainly to document mex integration.
Images
This config in MEX will use the serial connection on the far left hand side of the Interfacer 3
set baud 9600
set port 7
; be sure the correct stop bits etc. are set corectly
; In TeraTerm I found it helpful to set the 1k block checkbox.
; to receive using xmodem, M for modem 7; 'mr filename'
Documentation
Interfacer 3
Mex overlay
extract the .asm file
